Repeat Parameters on Like Edges

Do you need to place a delay, setup, or hold between every clock edge and another signal? Then, follow these simple steps:

1. Add a delay, setup, or hold between any two signal edges in the diagram.
2. Double click on the parameter name to open up the Parameter Properties Dialog box.
3. Left click on the "Repeat" button. This causes parameters to be added to like edges.

Watch as the parameter D0 is added to all like edges.

Back to Application Notes

Direct Sales Line: 800-804-7073 | Phone: 540-953-3390 | Email: Sales Office | Fax: 540-953-3078

Home | Timing Diagram Editor | Verilog Simulator | VHDL Verilog TestBench Generator
About SynaptiCAD

COPYRIGHT 2013, SYNAPTICAD SALES, INC., ALL RIGHTS RESERVED.